Satellite Freedom User Manual download pdf (Page 4)

PN 21337 REV B - 4 - 3-16-12

Install Angles on Floor:

1) Place floor P/N 21268 on a table or

box with textured side up. Layout 3 long

angles P/N 18039 with short flange on

floor.

2) Rivet long angles to floor using rivets

P/N 14351. Align holes in angles with

holes in floor. Rivets from bottom of floor

with washer P/N 11315 on top of angle.

3) Rivet short angles (2) PN 21270 to left

& right sides near front of floor using

rivets P/N 14351with washer P/N 11315.

Install Front Mount Bracket on Floor: Install Panels on Floor Angles:

4) Use screws (4) PN 16808 bottom of

front & nuts (4) PN 13131 on top of

brackets (2) PN 21271 to secure front

mount brackets to front of floor. Match

holes in bracket with holes in floor.

Tighten screws & nuts using T-30 Torx

bit & 1/2” (.500”) [12.2 mm] Open end

wrench.

5) Rivet the left / right / rear panels to

long floor angles Position panels on

outside of angles so holes in bottom of

panels match holes in angles. Install

rivets P/N 11054 from inside unit through

hole in angle and into hole in panel.

Place washers P/N 11315 onto rivets

outside of panel and set rivets.

6) Rivet the left / right / rear panels to

long floor angles.

Rivet side Panels to rear Panel: Install Front:

7) Rivet rear panel to left panel (rear

panel overlaps left side panel). Rivet

right side panel (right side panel

overlaps rear panel) to rear panel. Use

rivets P/N 11054 from outside of panel &

washers P/N 11315 on the inside of

panels.

8) Drill at dimple locations in bottom of

right facing using a 21/64” (.328”) [8.3

mm] drill bit. (Tip: bend right edge of

facing inward prior to installation)

9) Position right facing behind mount

bracket PN 21271 on floor. Fasten right

facing to bracket using screws PN 16808

through bracket into hole drilled in facing,

nuts PN 13131 on inside of facing.

Tighten screw & nut using T-30 Torx bit

& 1/2” (.500”) [12.2 mm] open end

wrench.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments